Red Hat ENTERPRISE LINUX 3 - FOR X86-ITANIUMTM-AMD64 AND INTEL EXTENDED MEMORY 64 TECHNOLO Uživatelský manuál Strana 3

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 12
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 2
Page 3
Preserving Your Oracle Database 10g Environment
when Upgrading from Red Hat Enterprise Linux 2.1
AS to Red Hat Enterprise Linux 3
OVERVIEW
When you perform a clean install of Red Hat Enterprise Linux 3 (RHEL3) on a
system that has Oracle Database 10g installed on Red Hat Enterprise Linux 2.1
AS (RHAS2.1), you must preserve the Oracle Database 10g environment. This
white paper explains how.
INTRODUCTION
When you upgrade from RHAS2.1 to RHEL3, Red Hat strongly recommends
that you do a full application and data backup, followed by a fresh install of
RHEL3 over the previous version. This procedure is described in Migrating to
Red Hat Enterprise Linux – Benefits and Guidelines at:
http://www.redhat.com/whitepapers/rhel/RHEL3Migration
WPSO.pdf
Oracle directories are usually not located in system directories, so they will not
be overwritten by a clean install. However, the install will overwrite all files in
system directories such as /, /boot, /etc, /var, /home, and /usr. If you have
installed any Oracle directories, such as the Oracle base directories, Oracle
inventory directory, Oracle home, or Cluster Ready Services (CRS) home
directories, in system directories, you must fully back them up before you
perform the upgrade. After the upgrade, restore these directories to their original
locations.
You must preserve certain configuration files to ensure correct Oracle operation
after the RHEL3 install. Some of these files were created or modified when you
did the pre-installation tasks described in Oracle Database Installation Guide:
10g Release 1 (10.1) for UNIX Systems: AIX-Based Systems, hp HP-UX, hp
Tru64 UNIX, Linux, and Solaris Operating System (SPARC) Part No. B10811-
02. Other files were created by Oracle Universal Installer during the Oracle
Database 10g installation. This document describes how to save and restore
those files.
Zobrazit stránku 2
1 2 3 4 5 6 7 8 ... 11 12

Komentáře k této Příručce

Žádné komentáře