Red Hat NETSCAPE MANAGEMENT SYSTEM 4.5 Uživatelský manuál stáhnout pdf (Strana 221)

Networking

221

www.vmware.com

Forcing the Network Driver to Use

a Specific Speed

The VMkernel network device drivers start with a default setting of 100Mbps, full

duplex. This setting should work correctly with network switches set for 100Mbps, full

duplex and with switches set to autonegotiate.

If you encounter problems — in particular, very low receive speeds — it is likely that

your switch is set for 100Mbps, half duplex.

To resolve the problem, either change the settings on your switch or change the

settings for the VMkernel network device using the VMware Management Interface.

1. Log in to the management interface as root.

2. Go to the Network Configuration page (Configure System > Network

Configuration).

3. Locate the device you want to reconfigure and choose the appropriate setting

from the drop-down list in the New Speed/Duplex column.

4. Click Update Network Configuration.

1 2 ... 216 217 218 219 220 221 222 223 224 225 226 ... 285 286

Žádné komentáře

Red Hat NETSCAPE MANAGEMENT SYSTEM 4.5 Uživatelský manuál Strana 221