Red Hat NETSCAPE MANAGEMENT SYSTEM 6.01 - CUSTOMIZATION Servisní příručka stáhnout pdf (Strana 25)

LEGATO NetWorker, Release 6.0.1-x, HP OpenVMS Version

Release Supplement

Chapter 2: OpenVMS I64 Supplement

This release of NetWorker supports the OpenVMS I64 operating system. There are

very few differences between NetWorker for OpenVMS Alpha and I64. This chapter

describes the differences for the OpenVMS I64 operating system. The following topics

are included in this chapter:

• "Operating System Requirements" on page 25

• "Installation" on page 25

• "Installation In A Mixed Cluster" on page 25

• "Recovering an OpenVMS V8.2 System Disk" on page 26

• "Known Limitations" on page 26

Operating System Requirements

NetWorker release 6.0.1-D requires OpenVMS I64 Version 8.2 as a minimum.

Installation

The installation of NetWorker on the OpenVMS I64 operating system is the same as

installing it on OpenVMS Alpha except that the filenames of the self-extracting archive

and PCSI file are different. The self-extracting archive filename is:

LGTO-I64VMS-SNCLNT-V0600-1D-1.EXE. The PCSI filename is

LGTO-I64VMS-SNCLNT-V0600-1D-1.PCSI.

Installation In A Mixed Cluster

When installing NetWorker in a mixed cluster of OpenVMS Alpha and OpenVMS I64

operating systems, you must install the appropriate kit on the appropriate operating

system. Also, you cannot have a common NSR$SYSTEM. If you install NetWorker on

the system disk, there should be no problem because you must have a separate system

disk for each architecture. If you specify the destination with the /DESTINATION

qualifier when installing the SNCLNT, be sure to specify a different destination for

each architecture. See the installation manual on installation using the

/DESTINATION qualifier.

1 2 ... 20 21 22 23 24 25 26 27 28

Žádné komentáře

Red Hat NETSCAPE MANAGEMENT SYSTEM 6.01 - CUSTOMIZATION Servisní příručka Strana 25